Changes

Jump to navigation Jump to search
285 bytes added ,  00:49, 10 October 2017
no edit summary
Line 153: Line 153:  
== GetStateChangeEvent ==
 
== GetStateChangeEvent ==
 
Returns an event handle for state changes. Signalled when Switch<->host USB comms change between started/stopped. USB cable connected/disconnected while at least 1 interface was enabled, or interface enabled/disabled while the USB cable was connected which then caused USB-comms state to change.
 
Returns an event handle for state changes. Signalled when Switch<->host USB comms change between started/stopped. USB cable connected/disconnected while at least 1 interface was enabled, or interface enabled/disabled while the USB cable was connected which then caused USB-comms state to change.
 +
 +
This is signalled before the endpoints are actually ready for data-transfer - there's currently no known way to properly check for that.
    
== SetVidPidBcd ==
 
== SetVidPidBcd ==
Line 231: Line 233:     
=== GetSetupEvent ===
 
=== GetSetupEvent ===
Returns an event handle. Unknown what triggers signalling.
+
Returns an event handle. Unknown what triggers signalling, not signalled during interface-enable / device<>host USB-comms init.
    
=== EnableInterface ===
 
=== EnableInterface ===
Line 290: Line 292:     
Used for data-transfer with input/output endpoints.
 
Used for data-transfer with input/output endpoints.
 +
 +
The user-process must flush dcache for the buffer before using this command.
    
==== GetCompletionEvent ====
 
==== GetCompletionEvent ====

Navigation menu