Changes

Line 484: Line 484:  
Tsi: non-value-0xFF to Set (BSA message 0x8CA), value 0xFF to Exit (BSA message 0x8CB).
 
Tsi: non-value-0xFF to Set (BSA message 0x8CA), value 0xFF to Exit (BSA message 0x8CB).
   −
Set: this uses HCI_Set_MWS_Signaling command with data determined using the input u8. Then this uses Broadcom HCI vendor command 0xFD95 with param_len=0x2: param +0x0 = 0x1, +0x1 = {Tsi value}. When this vendor command is successful, it then uses HCI_Sniff_Mode command with data selected using the Tsi value as the array-index. If the remote device doesn't support this (status indicating error with Mode Change Event for the response to HCI_Sniff_Mode), an error will be thrown via the [[#GetHidEventInfo|EventInfo]].
+
Set: this uses command HCI_Set_MWS_Signaling with data determined using the input u8. Then this uses Broadcom HCI vendor command 0xFD95 with param_len=0x2: param +0x0 = 0x1, +0x1 = {Tsi value}. When this vendor command is successful, it then uses command HCI_Sniff_Mode with data selected using the Tsi value as the array-index. If the remote device doesn't support this (status indicating error with Mode Change Event for the response to HCI_Sniff_Mode), an error will be thrown via the [[#GetHidEventInfo|EventInfo]].
 +
 
 +
Exit: this uses command HCI_Exit_Sniff_Mode.
    
== EnableBurstMode ==
 
== EnableBurstMode ==