Switch 2: Chat services

These services are S2-only.

chat:u

This is "nn::chat::IUserService".

Official sw uses domains with this.

Cmd	Name
0
2
10
11
14
15
16
20
21
22
23
40
51
60
61
70
71
72

Cmd0

No input, returns an IUserShimScopedObject.

Cmd2

No input, returns an IUserLayoutCustomizationShimScopedObject.

IUserShimScopedObject

This is "nn::chat::IUserShimScopedObject".

Cmd	Name
1
2	AttachToRoomInfoChangedEvent
3	AttachToLocalCameraImageProcessingModeChangedEvent
4	AttachToLocalCameraZoomMagnificationChangedEvent
10	StartLocalCameraStreaming
11	StopLocalCameraStreaming
20	StartRemoteCameraStreaming
21	StopRemoteCameraStreaming
30	CreateAudioStreamWorkBuffer
31	DestroyAudioStreamWorkBuffer
32	GetAudioStreamCapacityFrameCount
33	StartAudioStreamRecording
34	StopAudioStreamRecording
35	GetAudioStreamFreeFrameCount
36	GetAudioStreamFilledFrameCount
37	ReadAudioStream

Cmd1

No input, returns an output Event handle with EventClearMode=0.

AttachToRoomInfoChangedEvent

No input, returns an output Event handle with EventClearMode=0.

AttachToLocalCameraImageProcessingModeChangedEvent

No input, returns an output Event handle with EventClearMode=0.

AttachToLocalCameraZoomMagnificationChangedEvent

No input, returns an output Event handle with EventClearMode=0.

IUserLayoutCustomizationShimScopedObject

This is "nn::chat::IUserLayoutCustomizationShimScopedObject".

Official sw from BeginFullScreenWithLocalCameraAvailableSection uses cmd20 cmd10, cmd11, cmd13 (the exact cmds used depends on input). Depending on input, this may also launch the relevant applet with ForFullScreen.

Cmd	Name
0	Initialize
1
10
11
12	EndFullScreenWithLocalCameraAvailableSection
13
20

Cmd1

No input, returns an output Event handle with EventClearMode=0.

Used by official sw immediately after Initialize.

chat:wu

This is "nn::chat::IWebUserService".

Cmd	Name
1

Cmd1

No input. Returns an IWebUserShimScopedObject.

IWebUserShimScopedObject

This is "nn::chat::IWebUserShimScopedObject".

Cmd	Name
1
2
3

Cmd0

No input, returns an output u8.

Cmd1

No input, returns an output Event handle with EventClearMode=0.

Cmd2

No input, returns an output u32.