4,620
edits
Changes
no edit summary
** That func does:
** That func does:
** Gets [[System_Settings|system-setting]] <code>nim.errorsimulate!error_localcommunication_result</code>, returning that as an error if set + non-zero.
** Gets [[System_Settings|system-setting]] <code>nim.errorsimulate!error_localcommunication_result</code>, returning that as an error if set + non-zero.
** Does socket setup.
** Does socket setup:
** Calls a func.
** Calls a func.
** When any of the above fail (including the system-setting), the Result is written into state, then the Result is returned.
** When any of the above fail (including the system-setting), the Result is written into state, then the Result is returned.
*** All IDs in the below table are implemented by the server, even 0x3 for SystemUpdate.
*** All IDs in the below table are implemented by the server, even 0x3 for SystemUpdate.
*** An error is thrown if the ID is unrecognized. An error is thrown if the value of the request size1 doesn't match the expected fixed value (except for ID 0x0).
*** An error is thrown if the ID is unrecognized. An error is thrown if the value of the request size1 doesn't match the expected fixed value (except for ID 0x0).
The above socket setup for the Send async thread does the following:
* Clears sockaddr_in and sets addrlen to 0x10.
* Enters a loop which repeatedly calls a func. If that func fails, this will immediately return.
* Within that loop the following is done:
** sockfd = accept(listen_sockfd, &sockaddr_in, &addrlen); {handle error on fail - listen_sockfd is the saved sockfd from [[#Cmd76]]}
** Exits the loop when the ipaddr within sockaddr_in matches the saved ipaddr in state from [[#Cmd76]] (originally from the cmd input param). Otherwise, close sockfd and continue the loop (with the above func being called again).
* The following is done after the loop:
* u64 tmpval=1; setsockopt(sockfd, SOL_SOCKET, SO_VENDOR + 0x1, &tmpval, sizeof(tmpval)); {handle error on fail}
* Uses a service cmd, returning an error if this is successful. Hence, the output from this is ignored.
* Uses fcntl with F_GETFL/F_SETFL to clear O_NONBLOCK with sockfd, handling error on fail.
* u32 tmpval2=0x4000;
* u32 tmpval3=0x20000;
* setsockopt(sockfd, SOL_SOCKET, SO_RCVBUF, &tmpval2, sizeof(tmpval2)); {error is ignored}
* setsockopt(sockfd, SOL_SOCKET, SO_SNDBUF, &tmpval3, sizeof(tmpval3)); {error is ignored}
* Writes sockfd to the output state sockfd and returns 0.
** The func used with the above loop does the following:
** Uses select() with input setup for {content of readfds = sockfd}, and timeval setup for a 1-second timeout. This is used repeatedly, until this returns an error (in which case error handling is done) or returns non-zero.
** Then this returns 0.
Messages (requests/replies) begin with the following 0x10-byte header, then any associated data.
Messages (requests/replies) begin with the following 0x10-byte header, then any associated data.