Changes

| 3 || [[#GetStateChangeEvent]] ||  

| 3 || [[#GetStateChangeEvent]] ||  

|-

|-

| 4 || || No input. Returns an output u32. Returns an error when [[#BindDevice]] wasn't used.

| 4 || [[#GetState]] ||

|-

|-

| 5 || [[#SetVidPidBcd]] ||  

| 5 || [[#SetVidPidBcd]] ||  

== GetStateChangeEvent ==

== GetStateChangeEvent ==

Returns an event handle for state changes. Signalled when Switch<->host USB comms change between started/stopped. USB cable connected/disconnected while at least 1 interface was enabled, or interface enabled/disabled while the USB cable was connected which then caused USB-comms state to change.

Returns an event handle for when the state returned by [[#GetState]] changes. Signalled when Switch<->host USB comms change between started/stopped. USB cable connected/disconnected while at least 1 interface was enabled, or interface enabled/disabled while the USB cable was connected which then caused USB-comms state to change.

This is signalled before the endpoints are actually ready for data-transfer - there's currently no known way to properly check for that.

 

Returns the current state. Values:

* ...

== SetVidPidBcd ==

== SetVidPidBcd ==