EMMC pinout
Revision as of 07:34, 10 September 2021 by SciresM (talk | contribs) (Reverted edits by ColeJByrne (talk) to last revision by Stuckpixel)
Front
Back
Supply power via the VCC 3.3V and 1.8V pins, and solder the CLK, CMD, and DAT0 pins to an SD Card reader in order to extract the data off the eMMC chip.
eMMC Connector
| Pin # | Name | Type |
|---|---|---|
| 1 | 3.3v | PWR |
| 2 | GND | PWR |
| 3 | CMD | BI |
| 4 | GND | PWR |
| 5 | DAT_STRB(?) | OUT |
| 6 | GND | PWR |
| 7 | DAT4 | BI |
| 8 | GND | PWR |
| 9 | DAT5 | BI |
| 10 | GND | PWR |
| 11 | DAT6 | BI |
| 12 | GND | PWR |
| 13 | DAT7 | BI |
| 14 | GND | PWR |
| 15 | 1.8v | PWR |
| 16 | 1.8v | PWR |
| 17 | GND | PWR |
| 18 | GND | PWR |
| 19 | DAT2 | BI |
| 20 | GND | PWR |
| 21 | DAT1 | BI |
| 22 | GND | PWR |
| 23 | DAT0 | BI |
| 24 | GND | PWR |
| 25 | DAT3 | BI |
| 26 | GND | PWR |
| 27 | CLK | IN |
| 28 | GND | PWR |
| 29 | RESET | IN |
| 30 | 3.3v | PWR |
The eMMC connector plug on the board mates with the receptacle on the Switch motherboard. The receptacle is a Molex 5009130302, and is available from retailers such as Digi-Key.