Settings services

set

Cmd	Name
0	GetLanguageCode
1	SetLanguageCode
3
4

set:cal

Cmd	Name
0	GetBdAddress
1	GetConfigurationId1
2	GetAccelerometerOffset
3	GetAccelerometerScale
4	GetGyroscopeOffset
5	GetGyroscopeScale
6	GetWlanMacAddress
7	GetWlanCountryCodesNum
8	GetWlanCountryCodes
9	GetSerialNumber
10
11
12	GetBatteryLot
14	GetDeviceCertECC
15	GetETicketCertRSA
16	GetSslKey
17	GetSslCert
18	GetGamecardKey
19	GetGamecardCert
20	GetDeviceKeyECC
21	GetETicketKeyRSA
22	GetSpeakerCalibrationValues

Used for accessing data calibrated at the factory.

GetDeviceCertECC

Takes a type-0x16 output buffer with fixed size 0x180.

Returns the DeviceCert. This is identical to 3DS DeviceCert/CTCert besides the strings. NIM loads the DeviceId from this.

GetETicketCertRSA

Takes a type-0x16 output buffer with fixed size 0x240.

Same as GetDeviceCertECC, except this returns more data and the data starts differing at offset 0x108 compared to GetDeviceCert.

GetSslKey

Takes a type-0x16 output buffer with fixed size 0x134.

Returns a container-structure for the encrypted TLS client-privk. Decrypting this fails unless an unknown size >0x134 is passed to this setcal cmd?

Used by SSL-sysmodule, see here.

GetSslCert

Takes a type-0x16 output buffer with fixed size 0x804.

Returns a container-structure for the plaintext TLS client-cert.

Used by SSL-sysmodule, see here.

setcal Container Structure

Offset	Size	Name
0x0	0x4	Size (same size used for decryption if needed)
0x4	{above size}	Actual data starts here.

set:sys

Cmd	Name
3	GetSystemVersion
37	QuerySetting
38	ReadSetting
56	GetWirelessCertification
62	GetDebugMode
68	GetSerialNumber

Official user-processes get a new service session handle each time a set:sys cmd is used, with the session being closed aftewards.

ReadSetting

Takes two type-0x19 input buffers and a type-0x6 output buffer. Returns an output u64 for the actual size written to the outbuf.

The outbuf_size is compared with the config_size. When config_size is larger than outbuf_size, outbuf_size is used for the memcpy, otherwise config_size is used. Afterwards the size used for the memcpy is written to output(see above).

If loading from main config fails, it will also attempt to load config from various state if the input strings match hard-coded strings.

GetSystemVersion

Takes a type-0x1A output buffer. User-processes use hard-coded size 0x100.

If needed, reads the content of the System_Version_Title "/file" into state. This is only done once.

Then the above 0x100-byte data is copied to the output buffer.

GetDebugMode

Returns an output u8.

Loads the 1-byte config for <"settings_debug", "is_debug_mode_enabled">. If that fails, value 0x1 is written to output. This uses the same func as ReadSetting internally.

Returned retval is always 0.

GetSerialNumber

Returns the 0x18-byte SerialNumber string.