Difference between revisions of "EMMC pinout"
Jump to navigation
Jump to search
Stuckpixel (talk | contribs) (Add full eMMC connector pinout) |
Stuckpixel (talk | contribs) m (add reset pin to eMMC connector pinout.) |
||
| Line 130: | Line 130: | ||
|- | |- | ||
| 29 | | 29 | ||
| − | | | + | | RESET |
| − | | | + | | IN |
|- | |- | ||
| 30 | | 30 | ||
Revision as of 01:07, 19 June 2020
Front
Back
Supply power via the VCC 3.3V and 1.8V pins, and solder the CLK, CMD, and DAT0 pins to an SD Card reader in order to extract the data off the eMMC chip.
eMMC Connector
| Pin # | Name | Type |
|---|---|---|
| 1 | 3.3v | PWR |
| 2 | GND | PWR |
| 3 | CMD | BI |
| 4 | GND | PWR |
| 5 | DAT_STRB(?) | OUT |
| 6 | GND | PWR |
| 7 | DAT4 | BI |
| 8 | GND | PWR |
| 9 | DAT5 | BI |
| 10 | GND | PWR |
| 11 | DAT6 | BI |
| 12 | GND | PWR |
| 13 | DAT7 | BI |
| 14 | GND | PWR |
| 15 | 1.8v | PWR |
| 16 | 1.8v | PWR |
| 17 | GND | PWR |
| 18 | GND | PWR |
| 19 | DAT2 | BI |
| 20 | GND | PWR |
| 21 | DAT1 | BI |
| 22 | GND | PWR |
| 23 | DAT0 | BI |
| 24 | GND | PWR |
| 25 | DAT3 | BI |
| 26 | GND | PWR |
| 27 | CLK | IN |
| 28 | GND | PWR |
| 29 | RESET | IN |
| 30 | 3.3v | PWR |
The eMMC connector plug on the board mates with the receptacle on the Switch motherboard. The receptacle is a Molex 5009130302, and is available from retailers such as Digi-Key.