WLAN services: Difference between revisions

Line 213:

If RequestWakeUp fails it will immediately return the Result, unless the Result is one of the following:

* 0xE86B: Sends message InitalizeWlanDriver, returning a Result on failure. Then message GetStateBeforeSleep is sent. If the output state is 0x1, it returns 0. If not 0x2 or the second output field is non-zero, it will Abort. Uses GetState to verify the state is valid, returning the Result from that on failure. Otherwise this will return the Result from sending command request 0x99 with param=0.

* 0xE86B (normal non-wowl codepath was previously used during RequestSleep): Sends message InitalizeWlanDriver, returning a Result on failure. Then message GetStateBeforeSleep is sent. If the output state is 0x1, it returns 0. If not 0x2 or the second output field is non-zero, it will Abort. Uses GetState to verify the state is valid, returning the Result from that on failure. Otherwise this will return the Result from sending command request 0x99 with param=0.

* 0xE66B: Sends message 0x3E. Uses GetState to verify the state is valid, when valid then message DisconnectRequest is sent. If state-validation/DisconnectRequest failed this will Abort, otherwise this then returns 0.

@@ Line 213: / Line 213: @@
 If RequestWakeUp fails it will immediately return the Result, unless the Result is one of the following:
-* 0xE86B: Sends message InitalizeWlanDriver, returning a Result on failure. Then message GetStateBeforeSleep is sent. If the output state is 0x1, it returns 0. If not 0x2 or the second output field is non-zero, it will Abort. Uses GetState to verify the state is valid, returning the Result from that on failure. Otherwise this will return the Result from sending command request 0x99 with param=0.
+* 0xE86B (normal non-wowl codepath was previously used during RequestSleep): Sends message InitalizeWlanDriver, returning a Result on failure. Then message GetStateBeforeSleep is sent. If the output state is 0x1, it returns 0. If not 0x2 or the second output field is non-zero, it will Abort. Uses GetState to verify the state is valid, returning the Result from that on failure. Otherwise this will return the Result from sending command request 0x99 with param=0.
 * 0xE66B: Sends message 0x3E. Uses GetState to verify the state is valid, when valid then message DisconnectRequest is sent. If state-validation/DisconnectRequest failed this will Abort, otherwise this then returns 0.