Difference between revisions of "EMMC pinout"
Jump to navigation
Jump to search
Stuckpixel (talk | contribs) m (add reset pin to eMMC connector pinout.) |
ColeJByrne (talk | contribs) m (→eMMC Connector) |
||
Line 138: | Line 138: | ||
|} | |} | ||
− | The eMMC connector plug on the board mates with the receptacle on the Switch motherboard. The receptacle is a [http://www.molex.com/molex/products/datasheet.jsp?part=active/5009130302_PCB_RECEPTACLES.xml&channel=Products&Lang=en-US Molex 5009130302], and is available from retailers such as [https://www.digikey.com/product-detail/en/molex-llc/5009130302/WM6833CT-ND/3045233 Digi-Key]. | + | The eMMC connector plug on the board mates with the receptacle on the Switch motherboard. The receptacle is a [http://www.molex.com/molex/products/datasheet.jsp?part=active/5009130302_PCB_RECEPTACLES.xml&channel=Products&Lang=en-US Molex 5009130302], and is available from retailers such [https://wiki.pine64.org/index.php/PinePhone as] [https://www.digikey.com/product-detail/en/molex-llc/5009130302/WM6833CT-ND/3045233 Digi-Key]. |
Revision as of 14:22, 9 September 2021
Front
Back
Supply power via the VCC 3.3V and 1.8V pins, and solder the CLK, CMD, and DAT0 pins to an SD Card reader in order to extract the data off the eMMC chip.
eMMC Connector
Pin # | Name | Type |
---|---|---|
1 | 3.3v | PWR |
2 | GND | PWR |
3 | CMD | BI |
4 | GND | PWR |
5 | DAT_STRB(?) | OUT |
6 | GND | PWR |
7 | DAT4 | BI |
8 | GND | PWR |
9 | DAT5 | BI |
10 | GND | PWR |
11 | DAT6 | BI |
12 | GND | PWR |
13 | DAT7 | BI |
14 | GND | PWR |
15 | 1.8v | PWR |
16 | 1.8v | PWR |
17 | GND | PWR |
18 | GND | PWR |
19 | DAT2 | BI |
20 | GND | PWR |
21 | DAT1 | BI |
22 | GND | PWR |
23 | DAT0 | BI |
24 | GND | PWR |
25 | DAT3 | BI |
26 | GND | PWR |
27 | CLK | IN |
28 | GND | PWR |
29 | RESET | IN |
30 | 3.3v | PWR |
The eMMC connector plug on the board mates with the receptacle on the Switch motherboard. The receptacle is a Molex 5009130302, and is available from retailers such as Digi-Key.